Mop Head Installation Methods

Jun 01, 2026

Leave a message

Rotary Mop Head Installation
‌Steps‌: Place the new mop head flat on the ground. Align the mop handle with the center and rotate it clockwise; stop turning once you hear a "click" indicating it is in place-do not force it further.
‌Alternative Method‌: Align the mop plate with the slots on the mop head and press down vertically. Gently step on the mop plate with your toe; a snapping sound indicates the installation is complete.

 

PVA/Sponge Mop Head Installation
‌Steps‌: First, wet the new sponge head to soften it. Position the thinner end facing down and align it with the mop's mounting slot; push down firmly while squeezing inward until you hear a "click," indicating it is locked in place.
‌Alternative Method‌: Align the four mounting tabs on the sponge head with the corresponding slots on the mop. Press them firmly inward and then push slightly forward; the installation is complete if it does not detach when pulled.

 

Flat Mop Head Installation
‌Clip-on Type‌: Place the mop pad on the ground, align the mop clips with the edges of the pad, and press down firmly until you hear a "click" indicating it is secured.
‌Velcro Type‌: Align the new mop pad with the Velcro surface and press firmly from one end to the other to ensure a secure fit, making sure there are no curling edges.
‌Direct-Connect Type‌: Align the bottom of the mop handle with the socket on the back of the mop head and press down vertically; a "click" sound indicates the mechanism has locked into place.

Next: No Information

Send Inquiry